※ Characteristics and effects are as follows.

• Stainless pigment(thin section) becomes a continuous laminated film to completely block contacts with water or air.
• Formation of stainless films on the surface of all materials.
• Long-term protection : From corrosion, erosion, rust, wear, deterioration, contamination, etc. of all materials.
• Insulation and heat retention : Due to the excellent properties of stainless steel, it reflects heat and light and provides high heat retention due to its extremely low thermal conductivity.
• Non-conductive : Can be used for electrical and electronic components.
• Forms a dense, continuous layered film : Offers excellent protection against damage or wear from water, moisture, and heat.
• UV resistance and weatherproof : Protects against ultraviolet rays and atmospheric effects, maintaing its gloss for years.
• Strong water and moisture resistance performance.

• Vessel, vehicle, power generation facility, building, outdoor steel structure, various machines.
• Boiler, heating & cooling piping, ironworks, casting plant, glass plant.
• Fuel tank, steel pipe, muffler, radiator, heating & cooling equipment.
• Surfaces of metal, wood, concrete, mortar, rubber, plastic, and paper.

• Remove dust, oil, rust, etc. from the application surface.
• Shake up and down lightly before use.
• Spray 2 - 3 times from a distance of 20 ~ 30 cm from the coating surface.
  (When painting, do not apply a single coating of the desired thickness at once, but divide it into several applications.)
• Apply it again depending on desired thickness.
• Time for tack free drying is about 2∼3 minutes.
• Complete hardening takes 24 hours.
• Use the target after complete hardening.

• This should be used only for its intended purpose.
• Ventilation is necessary when using the cleaner.
• Do not inhale it for a long period of time.
• Avoid long contact with skin.
• Test prior to applying for Fluorine resin and Fluorine rubber products, because the Fluorine solvents is used.
• As a flammable product using compressed gas, it is dangerous. Please observe the following precautions.
  1. Do not use it toward fire.
  2. Provide good ventilation for long-time use.
  3. Do not use near heater or stove.
  4. Do not keep it in the place above 40℃.
  5. Provide ventilation to use it in the closed room.
  6. Do not throw it away into fire.
  7. Punch the can to throw it away.
  8. Spraying may not work well below 5℃.
  9. Be careful, as exposure to direct sunlight or heat may cause an explosion.
  10. Check for sparks in the vicinity, wait for the gas to disperse after spraying a certain amount, and then reuse.