※The features and effects are as follows :

• Powerful Penetration and Dissolving Power.
• Safe on All Metals.
• Non-carcinogenic Compounds.
• High Fluidity.
• Quick Dissolving Action.
• Low Irritation.

• Peeling of enamel, paint, epoxy, polyurethane, acrylic, etc.
• Peeling of gaskets and sealants.
• Removal of mold deposits during injection molding
• Removal of carbon residues and heat-set oils.

• Always wear safety equipment before work.
• Spray method :
  1. Apply the product evenly to the exfoliation target.
  2. After a time, rub it by using scraper or brush to remove carbonate.
  3. Evenly apply product on the item to be cleaned. Wait for approximately 30~40 minutes, then scrub the area with a scraper or brush to remove the paint layer.
• Dipping method :
  1. Long-time dipping of target object causes exfoliation due to chemical action.
  2. Paint film expands to become bloated.
  3. When exfoliation is finished, clean the target by using soft cloth or high-pressure water.

• This should be used only for its intended purpose.
• Ventilation is necessary when using the cleaner.
• Do not inhale it for a long period of time.
• Avoid long contact with skin.
• Test prior to applying for Fluorine resin and Fluorine rubber products, because the Fluorine solvents is used.
• As a flammable product using compressed gas, it is dangerous. Please observe the following precautions.
  1. Do not use it toward fire.
  2. Provide good ventilation for long-time use.
  3. Do not use near heater or stove.
  4. Do not keep it in the place above 40℃.
  5. Provide ventilation to use it in the closed room.
  6. Do not throw it away into fire.
  7. Punch the can to throw it away.
  8. Spraying may not work well below 5℃.
  9. Be careful, as exposure to direct sunlight or heat may cause an explosion.
  10. Check for sparks in the vicinity, wait for the gas to disperse after spraying a certain amount, and then reuse.