※ Characteristics and effects are as follows.

• Paintable.
• Excellent release properties.
• Suitable for precision molds.
• Non-corrosive to molds.
• Leaves no residue.
• RoHS(6 type hazardous substances) undetected.

• Injection Molding : Used to easily remove plastic or rubber parts from molds without damage.
• Epoxy resin, phenolic resin, melamine resin, PVC resin, etc.

• Remove foreign substances on the coating surface and injection residues.
• Spray from a distance of about 20 cm from the coating surface.
• Depending on the work situation, finish by wiping or brushing with a cloth.

• This should be used only for its intended purpose.
• Ventilation is necessary when using the cleaner.
• Do not inhale it for a long period of time.
• Avoid long contact with skin.
• Test prior to applying for Fluorine resin and Fluorine rubber products, because the Fluorine solvents is used.
• As a flammable product using compressed gas, it is dangerous. Please observe the following precautions.
  1. Do not use it toward fire.
  2. Provide good ventilation for long-time use.
  3. Do not use near heater or stove.
  4. Do not keep it in the place above 40℃.
  5. Provide ventilation to use it in the closed room.
  6. Do not throw it away into fire.
  7. Punch the can to throw it away.
  8. Spraying may not work well below 5℃.
  9. Be careful, as exposure to direct sunlight or heat may cause an explosion.
  10. Check for sparks in the vicinity, wait for the gas to disperse after spraying a certain amount, and then reuse.