※ The characteristics and effects are as follows.

• Excellent appearance marking properties with superior weather-resistance fluorescent paint.
• Strong adhesion.
• Fast drying.
• Bright fluorescent finish.

※ Emergency exit guidance signs, Nighttime pedestrian walkway markings, switch markings, etc.,
can prevent various safety accidents that occur industrial sites.

• General use : For evacuation guidance markings, stairs and obstacles, emergency exit signage, interior work, and sculpture work, etc.
• Industrial use : For stairsm switches, safety walkways and pathways markings, safety precaution areas.
• Industrial field : Used for safety markings on the rear parts of various heavy-duty vehicles
  such as forklifts, as well as in factories, construction sites, highway, and staircases.

• Remove foreign substances from application surface to enhance work efficiency.
• Shake up and down lightly before use.
• Spray evenly from distance of about 20 ~ 30 cm from the application surface.
• Apply 2 - 3 times depending on the required thickness.
  (Do not apply thick coats at once, but apply thin coats repeatedly at 10-minute intervals, overlapping 2 - 3times).
• When there is remaining content after use, invert the container and release gas for about 2 seconds,
  then securely close the cap and store it.

• This should be used only for its intended purpose.
• Ventilation is necessary when using the cleaner.
• Do not inhale it for a long period of time.
• Avoid long contact with skin.
• Test prior to applying for Fluorine resin and Fluorine rubber products, because the Fluorine solvents is used.
• As a flammable product using compressed gas, it is dangerous. Please observe the following precautions.
  1. Do not use it toward fire.
  2. Provide good ventilation for long-time use.
  3. Do not use near heater or stove.
  4. Do not keep it in the place above 40℃.
  5. Provide ventilation to use it in the closed room.
  6. Do not throw it away into fire.
  7. Punch the can to throw it away.
  8. Spraying may not work well below 5℃.
  9. Be careful, as exposure to direct sunlight or heat may cause an explosion.
  10. Check for sparks in the vicinity, wait for the gas to disperse after spraying a certain amount, and then reuse.