※Characteristics and effects :

• It helps the engine operate at optimal performance by appropriately adjusting the mixture of fuel and air.
• It enhances fuel efficiency and improves engine responsiveness.

• Automobile and Motorcycle Carburetors : Removes oil residue and carbon deposits inside the carburetor to ensure smooth fuel flow and improve fuel efficiency.
• Throttle Body : Removes contaminants accumulated in the throttle body to enhance throttle response.
• Choke Valve : Ensures smooth operation of the choke valve to improve startability.
• Fuel Injection System : Removes contaminants from the nozzles and valves of the fuel injection system to enhance fuel injection efficiency.

• 1. Turn off the engine and cover to prevent spraying onto painted surfaces.
• 2. Remove the air cleaner.
• 3. Start the engine and increase idle speed. Spray thoroughly onto dirty areas such as injectors, carburetor, and internals.
• 4. Especially in heavily soiled areas like the throttle plate and choke valve, spray again.
• 5. Avoid causing engine overload and noise by spraying the entire can at once, as it may cause reverse flow into the engine.
  Instead, spray in short bursts of 1-2 seconds with 1 second intervals.

• This should be used only for its intended purpose.
• Ventilation is necessary when using the cleaner.
• Do not inhale it for a long period of time.
• Avoid long contact with skin.
• Test prior to applying for Fluorine resin and Fluorine rubber products, because the Fluorine solvents is used.
• As a flammable product using compressed gas, it is dangerous. Please observe the following precautions.
  1. Do not use it toward fire.
  2. Provide good ventilation for long-time use.
  3. Do not use near heater or stove.
  4. Do not keep it in the place above 40℃.
  5. Provide ventilation to use it in the closed room.
  6. Do not throw it away into fire.
  7. Punch the can to throw it away.
  8. Spraying may not work well below 5℃.
  9. Be careful, as exposure to direct sunlight or heat may cause an explosion.
  10. Check for sparks in the vicinity, wait for the gas to disperse after spraying a certain amount, and then reuse.